ENTTEC DMX-USB Pro question

[nishrigo]

Hi, I was wondering if the ENTTEC DMX-USB Pro can be configured to output using Artnet. If yes, I would like some pointer on how it can be done.

I recently recently read that the dot2 on PC version will output signal using a third party hardware using the Artnet protocol. I have been using the ENTTEC device very successfully with Chamsys MagicQ PC, but I was wondering if it would do the trick with the dot2onPC

 

[Mac Hosehead]

The onPC version of the MA dot2 console outputs DMX over ethernet in either ArtNet or sACN(E1.31) protocols. It has no support for USB interfaces. There is Linux software, called OLA, that will accept ArtNet or sACN as input and output DMX to USB interfaces such as the Enttec DMX Pro. This software is usually run on a separate computer and there are versions that will run on a Raspberry Pi or a Mac.

https://www.openlighting.org/ola/