ETC Express Bump Button Question

stagebuilder

Member
Joined
Apr 3, 2012
Location
San Francisco, CA
So I programmed a couple of chase effects for our students' dance concert into two submasters. I pushed one of the bump buttons and the chase locked on until I hit the bump button again and it stopped. I pushed the bump button for the other chase effect programed into the next submaster but this bump button is only momentary, not ON-OFF like I want it to be. I can't figure out from the manual how to change from momentary to ON-OFF. Any help?
 

Colin

Well-Known Member
Joined
Jan 23, 2015
Location
Eastern Massachusetts
I haven't touched Express in a while but I think you need to look into your effect's dwell time. A dwell time of "hold" will cause it to run in the sub until you bump it off. If you look at the effect times and have a dwell of other than hold, I recall pressing [clear] resets it to the default of hold.
 

MNicolai

Well-Known Member
Premium Member
Fight Leukemia
Joined
Mar 30, 2008
Location
Sarasota, FL
I haven't touched Express in a while but I think you need to look into your effect's dwell time. A dwell time of "hold" will cause it to run in the sub until you bump it off. If you look at the effect times and have a dwell of other than hold, I recall pressing [clear] resets it to the default of hold.
upload_2017-12-6_15-9-29.png
 

Users who are viewing this thread