ETC expression 2 & XGT Kurta Digitizer

ok so im at school at Fredonia and im working on our spring musical "Barnum" we have a series of apollo color scrollers. we brought up our Kurta XGT digitizer table yesterday and hooked it up to the board. its plugged in right and the board is responding to it... by that i mean that the board recognizes that its plugged in. here's our problem we need to calibrate the table so that we can use the controle sheet on it. we cant figure out how to do this... in the manual there are directions but for some reason they arent working. one possabiliyt is that the pen may be out of batteries, assuming that that is not the problem then there must be some sequence of F or P buttons that we need to hit on the table or some settings we missed on the ETC board. if anyone has any suggestions please leave me a post, all day tech for the show is next friday the fifteenth, please help me out before then. thanx.
 
Hmmm....

Have you tried calling ETC Tech Support ?.

800 688 4116

SB
 

Users who are viewing this thread

Back