Bryan Dauterive
Member
Hello everyone,
I recently did an installation for a small venue where I ran Cat 5 cables and terminated it on either end with Neutrik eathercon panel mounts. In the center of the room, I took the two cable feeds and soldered them together with another jumper cable to make a central patch port also terminated with a Neutrik eathercon panel mount. I am currently having trouble getting all 8 cables in the line to match up according to my tester. Do any of you know if it matters if A or B connector type is used as long as everything is the same termination?
I recently did an installation for a small venue where I ran Cat 5 cables and terminated it on either end with Neutrik eathercon panel mounts. In the center of the room, I took the two cable feeds and soldered them together with another jumper cable to make a central patch port also terminated with a Neutrik eathercon panel mount. I am currently having trouble getting all 8 cables in the line to match up according to my tester. Do any of you know if it matters if A or B connector type is used as long as everything is the same termination?