For starters, I am not sure if pigtail is the right word. On conventional lightning fixtures you usually have short cord with a male end on it. If I call that a pig tail am I using the wrong term?
For the rest of this post(until perhaps edited) I will call that piece of cord with in America probably fitted with a male stage pin, a "pig tail".
I like to use non mating ends for equipment that should never mate. On some of the equipment I would like to have PowerCon, since it does not mate with Schucko. However, today in my inventory there are some equipment that are equiped with a pig tail were I would like to have a PowerCon, power In. Have anyone here seen a good solution for this problem, that does not include always needing an expensive adapter?
I can not be the only one wanting this...
For the rest of this post(until perhaps edited) I will call that piece of cord with in America probably fitted with a male stage pin, a "pig tail".
I like to use non mating ends for equipment that should never mate. On some of the equipment I would like to have PowerCon, since it does not mate with Schucko. However, today in my inventory there are some equipment that are equiped with a pig tail were I would like to have a PowerCon, power In. Have anyone here seen a good solution for this problem, that does not include always needing an expensive adapter?
I can not be the only one wanting this...