Linear Effect Help

e.clarkson

Member
On the ETC TI, we have a stack of cues where a group of conventional channels are cycling infinitely through a linear fade effect. Most of the show is fine, but when the rate changes between cues we occasionally get channels that pop on much too fast. The only thing changing is the rate. The entry and exit is immediate and fade by size.

Any ideas on how to get them to stop doing that?
 
Last edited:
We have a stack of cues where a group of conventional channels are cycling infinitely through a linear fade effect. Most of the show is fine, but when the rate changes between cues we occasionally get channels that pop on much too fast. The only thing changing is the rate. The entry and exit is immediate and fade by size.

Any ideas on how to get them to stop doing that?
@e.clarkson Which console? Make, model, generation of software?
Toodleoo!
Ron Hebbard.
 
Is losing the channel permanent or temporary while the fade runs? It may have something to do with the Entry or Exit settings (immediate vs cascade) or the nature of the linear effect. You may want to ask this question on ETC's forums or call ETC support. They will know the right questions to ask to get to the root of issue. I'm just guessing.
 

Users who are viewing this thread

Back