Console don't really talk to the fixtures, they more yell something out and hope that it listens. Can you hard capture the dimmer(s) that you have the fixture addressed to and get anything to move? Do you have your ports set up correctly? Etc....I've been trying too but I am new to using the editor and don't know if the one I created is working. Can't seem to get console to talk with the fixtures.
Menir
I have used them on a MLC16. Have you used them before? They may be setup to take martins protocol instead of DMX. Martin protocol reverses pins 2 and 3 so that 3 is hot and 2 is ground. Also you need to make sure you have the dip switches set properly. you could be one channel off or something like that. Also try not using the terminator and see if things start to work. I really dont use terminators very often.
We use essential cookies to make this site work, and optional cookies to enhance your experience.