EWCguy
Active Member
I'm looking to replace our floor pockets -- the lighting connectors inside need to be replaced and I'm doubtful the lid will survive removal of the flange, there's so much black floor paint and varnish in the screws. Lid looks to be cast aluminum with textured top surface and logo/brand in center.
I'd like to replace with the same gear, installed 1982, but because of the paint, I can't read the US manufacturer/brand off the lid. Perhaps someone can think of brands from that period. A photo won't do much good, I can't even get a rubbing.
Pocket Details
Thanks for your advice!
I'd like to replace with the same gear, installed 1982, but because of the paint, I can't read the US manufacturer/brand off the lid. Perhaps someone can think of brands from that period. A photo won't do much good, I can't even get a rubbing.
Pocket Details
- 3-gang stage pin, lid has 3 cable slots.
- Lid/flange measurement: 10½ x 9 inches.
- Box opening roughly 7¼ x 5½ inches, could be 8x6 inch box.
- Connector plate is at an angle.
- Appears to be two words, all caps, italic
- Box with angled sides (matching the italic lettering) surrounds the two words
- Best guess is 4-letter word then 6-7-letter word
- First word guesses: TRIM, KRIM, RHIM...
- Second word guesses: CLIMNS, SI_MNG, SI_NRG...
Thanks for your advice!