I know NSI gear is not the greatest , but in my role as tech guy for a great outdoor community venue in beautiful Wisconsin it's what we have for now (summerstageofdelafield.com). We've been getting by with manual 2 scene control boards for a few years (most of our young folks have never even seen one before). I recently acquired a Melange Pro that looks fine, but behaves strangely! I never used one before , but am pretty good at following directions. The manual is at times vague, but here's what's happening with my attempts to program and run.
1. When I enter and load a few cues, they all show on the screen, but only 1 out of 3 or 4 will run! They all load into the fader, but the GO button, does nothing but advance to the next cue. Up and down timers don't change (but the delay timer always works.).
I don't know the history of this board and it is 17 years old, but any help would be greatly appreciated
1. When I enter and load a few cues, they all show on the screen, but only 1 out of 3 or 4 will run! They all load into the fader, but the GO button, does nothing but advance to the next cue. Up and down timers don't change (but the delay timer always works.).
I don't know the history of this board and it is 17 years old, but any help would be greatly appreciated