StephIsabel
Member
Hi all,
I have a very low-end LED controller with Cat5 ports that I am trying to run directly into an ETC Ion. I can't seem to make the light board see the controller, although the controller claims it can go directly into any DMX control system. I have tried all of the deep settings in the shell of the Ion to no avail. Anybody run into this problem?
I have a very low-end LED controller with Cat5 ports that I am trying to run directly into an ETC Ion. I can't seem to make the light board see the controller, although the controller claims it can go directly into any DMX control system. I have tried all of the deep settings in the shell of the Ion to no avail. Anybody run into this problem?