SM58 as a Clear Com mic

Footer

Senior Team
Senior Team
Premium Member
I picked up a used KB111A speaker station for my office to replace a full com setup I had. I'm looking to use an old 58 as the mic for this. Anyone know what I need to do to make it work? I got the 4 pin connector and the pinout, I'm specifically looking to see if I need to throw a resistor inline to drop the output a bit or something similar to that. Anyone else tried this?
 
I picked up a used KB111A speaker station for my office to replace a full com setup I had. I'm looking to use an old 58 as the mic for this. Anyone know what I need to do to make it work? I got the 4 pin connector and the pinout, I'm specifically looking to see if I need to throw a resistor inline to drop the output a bit or something similar to that. Anyone else tried this?
I've wired an adapter to the specs shared above and it "just worked". Basically the impedance and such is close enough to a dynamic headset mic that it works fine.
 

Users who are viewing this thread

Back