Stage Repaint or Replacement?

If you screw-up and need to reposition a panel after it is laid-down, make a garrotte with some dowel scrap or 2x2 for the handles and steel piano wire for the span between the handles, then work the wire under the edge of the panel and pull it along the length of the panel until it pops-out the other end. This will break the bond of the tape. Be extra careful to NOT get your fingers or any other appendage tangled-up in the wire, otherwise you may end-up missing that part from your body.
 
Last edited:
If you screw-up and need to re-position a panel after it is laid-down, make a garrotte with some dowel scrap or 2x2 for the handles and steel piano wire for the span between the handles, then work the wire under the edge of the panel and pull it along the length of the panel until it pops-out the other end. This will break the bond of the tape. Be extra careful to NOT get your fingers or any other appendage tangled-up in the wire, otherwise you may end-up missing that part from your body.
@teqniqal Is this what happened to your lengthy locks??
Toodleoo!
Ron Hebbard
 

Users who are viewing this thread

Back