urban79
Active Member
*Background*
My theatre has been closed for renovations since October, and hasn't had a show in since last March. Over that time, to install air conditioning, they took out the entire ceiling over the house; therefore all of the fixtures were removed and flown out over the stage. We're just in the final stages of getting the house turned back over to us, and so we started reinstalling fixtures.
*The issue*
I have two VL1100s on a foh electric. The first one reinstalled fine, went through its start up sequence and is behaving normally. The second however keeps the gobo wheel moving, permanently. It does shut off at times during the calibration sequence, but once it's homed it never shuts off. Any thoughts? I'm not a moving light tech, but I'm not completely unfamiliar with them and can do some basic maintenance/troubleshooting. I've attached a video of the entire calibration sequence to see if that provides any clues.
Much thanks!
Chris
My theatre has been closed for renovations since October, and hasn't had a show in since last March. Over that time, to install air conditioning, they took out the entire ceiling over the house; therefore all of the fixtures were removed and flown out over the stage. We're just in the final stages of getting the house turned back over to us, and so we started reinstalling fixtures.
*The issue*
I have two VL1100s on a foh electric. The first one reinstalled fine, went through its start up sequence and is behaving normally. The second however keeps the gobo wheel moving, permanently. It does shut off at times during the calibration sequence, but once it's homed it never shuts off. Any thoughts? I'm not a moving light tech, but I'm not completely unfamiliar with them and can do some basic maintenance/troubleshooting. I've attached a video of the entire calibration sequence to see if that provides any clues.
Much thanks!
Chris