soundofsparks
Active Member
Hey Everyone,
I'm having trouble with a Wybron CXI and I can't quite put my finger on what the problem might be. Here are some details. I've done a lot of troubleshooting here, but am happy to hear any thoughts obvious or less so.
For the most part, my fixture is behaving normally. The problem is that the frames are not aligning in the opening (off by about 1" or so). Both strings have the same problem (so the part of the opening that is actually in the correct color is 2" less wide). I've tried replacing the strings and retensioning the rollers, but I am always the same amount off. The really odd part is that I have two fixtures that are behaving the same way while the rest of my inventory is acting properly. I had talked with a distributor about the specifications of the Gel Strings should it be possible that the ones we have were not the right length, but it seems that they fit the specs.
The only thought I have is that this might be a be a problem with the spring in the one roller because when I have the device powered up and in a frame, I can move the scroller with my hand an inch or so without any real effort.
I know the roller replacement is involved, so I'm hesitant to start swapping parts with a good scroller just to see if it fixes it. I'd love to know if you all had any thoughts.
I'm having trouble with a Wybron CXI and I can't quite put my finger on what the problem might be. Here are some details. I've done a lot of troubleshooting here, but am happy to hear any thoughts obvious or less so.
For the most part, my fixture is behaving normally. The problem is that the frames are not aligning in the opening (off by about 1" or so). Both strings have the same problem (so the part of the opening that is actually in the correct color is 2" less wide). I've tried replacing the strings and retensioning the rollers, but I am always the same amount off. The really odd part is that I have two fixtures that are behaving the same way while the rest of my inventory is acting properly. I had talked with a distributor about the specifications of the Gel Strings should it be possible that the ones we have were not the right length, but it seems that they fit the specs.
The only thought I have is that this might be a be a problem with the spring in the one roller because when I have the device powered up and in a frame, I can move the scroller with my hand an inch or so without any real effort.
I know the roller replacement is involved, so I'm hesitant to start swapping parts with a good scroller just to see if it fixes it. I'd love to know if you all had any thoughts.