Mac Hosehead
Latest activityPostingsAbout
-
-
Mac Hosehead replied to the thread Patch panel to light board.This would be the way I would go as fooling around with analog control cable is something to avoid.The console is hardwired but is... -
Mac Hosehead replied to the thread Dove SceneMaster.It does say that to record a submaster, all submasters should be at zero. Just channel faders should have levels.
-
Mac Hosehead replied to the thread Dove SceneMaster.Even though it appears you can still buy these consoles new, I think it might be a good time to move along to something different. The...
-
Mac Hosehead replied to the thread Lights Turning Off Suddenly On Element 2 Board.This could/should be under warranty.Are there any DMX network nodes?
-
Mac Hosehead replied to the thread Etc to aurduino.Yes. I was thinking in the long run it might be easier to use QLC+ with an rpi, instead. https://www.qlcplus.org/discover/raspberry-pi...
-
Mac Hosehead replied to the thread DMX-sensing Relay?.Hah, it's good to know it works with 10mfd cap. Something else that should increase the time delay is adding a diode to the output of...
-
Mac Hosehead replied to the thread DMX-sensing Relay?.Need a card reader version.Here is a better way to add time delay to circuit:
-
-
Mac Hosehead replied to the thread DMX-sensing Relay?.You can try something like this but I like the timer circuit trigger idea better as it would appear more reliable.
-
-
Mac Hosehead replied to the thread 1977 Strand Century Lighting System.When I was in college there was a studio theatre that had a Strand system with a similar design and size. The lighting system for the...
-
Mac Hosehead replied to the thread Control/Dimming Are ETC Unison dimmers and Leviton/NSI iSeries compatible.Well, at least these have a 30 day warranty. I would probably trust them more than fire-sale power cubes.
-
Mac Hosehead replied to the thread DMX-sensing Relay?.Seems like you can still buy stuff: http://northlightdmx.com/DMXtoRelay.htm
-
Mac Hosehead replied to the thread Control/Dimming Are ETC Unison dimmers and Leviton/NSI iSeries compatible.If your ETC modules use the Q141 power cube then I would look to something used such as...
-
Mac Hosehead replied to the thread Open 4/12, dmx decoder/LED tape works from board not stage..It seems like it could be a termination issue. There was no mention of termination in the original post.
-
Mac Hosehead replied to the thread Expensive musicians chair.The chair looks cool but I assume this puts you in a situation where each musician expects their chair to be adjusted correctly prior to...
-
Mac Hosehead replied to the thread Sensor rack saying it's got a tripped breaker, when it doesn't?.It may have been in combination with another setting. I see the error that is being reported can be disabled in the settings of CEM+, so...
-
-
Loading…
-
Loading…
