Just downloaded the latest versions of 3d and onPC for the old desks, but they just will not recognise each other. I load up a show in the desk, then boot up 3d on the same dual monitor powerful computer and.................nuffink., I cant "join" a session, its greyed out, any help?
In OnPC... set the IP address to 127.0.0.1 (TCP/IP Local Loopback address)
Then start session...
Been a while since I used 3d... if there is an option to set ip address also use 127.0.0.1, and it should work.
RB
In OnPC... set the IP address to 127.0.0.1 (TCP/IP Local Loopback address)
Then start session...
Been a while since I used 3d... if there is an option to set ip address also use 127.0.0.1, and it should work.
RB
Thanks for the help but........the ip's are the same already although the console has 127.0.0.1(100) no idea what the 100 in parenthisis is about. and both programs are running on the same computer so cable isnt the problem
Sorry to bring back an old thread but My question involves the GrandMA 3d 2 software with on PC 2 software both are on the same network but it doesn't display the session.
Sorry to bring back an old thread but My question involves the GrandMA 3d 2 software with on PC 2 software both are on the same network but it doesn't display the session.
GrandMA onPC and GrandMA 3d need to be set where they have identical IP addresses (even run on same machine) and then the GrandMA 3d has to be the slave, and the MAonPC has to be the master. From there, I don't believe you'll be joining a session, rather you'll be automatically sync'd. If not, create a session, and have MA3d join it. Its been awhile since I've done it on my machine, but no problems since. The connection tab on the bottom will show a green heart, and your show will load up.
Oh, and always check your versions: MA won't sync up with other consoles, other PCs, other programs like 3d, or even iPhone remotes if the versions are different.
Yes it would. Set console to 192.168.0.1 or something like that. Set the PC to 192.168.0.xxx. make sure you are using a networkswitch if your networkadapter doesn't do auto switching.
Turn off your firewall. Make sure 3d is running as administrator. In the ma3d choose the same IP as what you set up on your networkadapter. You will need to close and reopen the program for this to take effect. On the console start a session and under the Visualizer ta b in net. work configuration choose add. Select you pc. You will now need to right click on the column session member so that it says yes. At this point the show should upload from the console. If you already started to add elements on the ma3d side. You should do this in reverse so that the starts the session.
I'll have to try that tomorrow, little late to run the software. I go them connected before but the MA3D just wont show the stage. I'll see if I can make it work though...
It's still a pretty decent guide. Just set your IPs like I mentioned instead of using loop back.
Like it mentions make sure you are using the same version of ma3d as you have on the desk.
Also make sure your session id is 1 on both units.