Hey all.
Using: American Lighting Products
4-wire (3 Hot, 1 Common) 24V, .96W (per lamp) "Clip Light" for a chase effect around an archway.
In-House System: ETC Sensor+ Dimmer Racks (2.4kW). Neutral is shared throughout.
Chase would be controlled via dimming system (not remote chase effect unit).
Question: In wiring the transformers to the bare ends of the "clip light" cable, the shared common would basically three-fer into the output of each of the transformers?
See diagram.
![TRANS DIAG.jpg TRANS DIAG.jpg](data:image/svg+xml;charset=utf-8,%3Csvg xmlns%3D'http%3A%2F%2Fwww.w3.org%2F2000%2Fsvg' width='1148' height='409' viewBox%3D'0 0 1148 409'%2F%3E)
Just so I'm not crazy. This should work, right?
Using: American Lighting Products
4-wire (3 Hot, 1 Common) 24V, .96W (per lamp) "Clip Light" for a chase effect around an archway.
In-House System: ETC Sensor+ Dimmer Racks (2.4kW). Neutral is shared throughout.
Chase would be controlled via dimming system (not remote chase effect unit).
Question: In wiring the transformers to the bare ends of the "clip light" cable, the shared common would basically three-fer into the output of each of the transformers?
See diagram.
![TRANS DIAG.jpg TRANS DIAG.jpg](https://www.controlbooth.com/data/attachments/2/2552-eb17deb5ad0526d358792faa7ff70ee9.jpg)
Just so I'm not crazy. This should work, right?