Hey all i just had a weird incident at my job a few days ago; we were setting up some truss and motors for a projection setup. All the motors were hooked up to the beams and to motor control, as we were testing the motors to make sure they were all working one of the chains hit the truss and started sparking. It looked as if the oil on the chain was popping off like in a grease fire, this was on 2 of the motors attached to the same piece of truss, one of the motors ceased to work right after this but the other was fine, so I'm not sure if that would have any correlation.
Just wanted to see if anyone has ever ran into anything like this before and if you know what was causing this?
-Thank you.
P.S. We were using a 30 amp 5 five wire plug, don't know if that makes a difference.
Just wanted to see if anyone has ever ran into anything like this before and if you know what was causing this?
-Thank you.
P.S. We were using a 30 amp 5 five wire plug, don't know if that makes a difference.