Tex
Active Member
I'm working in a theatre with Net 3 nodes, some of which were mounted to the wall during the install. It's obvious that they have been there since the building opened. On the electrics, the nodes are clamped to the pipe. Also on the pipe are female RJ45 jacks labeled "Net1" and "Net2". Nodes are plugged into the Net2 jack. Control is an Ion running the latest software. The nodes are in Net2 mode.
Has anyone seen this before? I don't understand why the older network was installed when Net3 was available and Net3 nodes were used. I need to reconfigure one of the nodes to be on an additional universe. Could I reconfigure using RDM from the console, or would I need to do it at the node?
Has anyone seen this before? I don't understand why the older network was installed when Net3 was available and Net3 nodes were used. I need to reconfigure one of the nodes to be on an additional universe. Could I reconfigure using RDM from the console, or would I need to do it at the node?