Recent content by Brad.O

Individually addressable LED strip lights (about $35/5m) and a simple Arduino processor to control can produce almost limitless effects and could be hardwired for on/off functions. Do some looking at what the Christmas guys are doing on YouTube for ideas and build-programming directions.

The PJ/lift is pretty atrocious if you ask me, even if it was black. For the amount of money invested in that PJ lift, the venue could have sourced a proper projector with interchangeable lenses that would support a throw from a concealed location - at worst, install into the underside of the...

Here's a handy source - these are used extensively in the HAM radio world for DC distribution so lots of suppliers.https://powerwerx.com/anderson-power-powerpole-sb-connectorsBrad

Assuming you are looking for a Category Cable Tx/Rx solution and not a true network transport solution.Based on the above - stick to only HDBaseT chipset units - the other proprietary units tend to have glitches and compatibility issues that make them problematic. Overall in hundreds of...

We have a need to convert a few channels of our existing dimmer-per-circuit installation into constant power to support LED and ML loads.Wondering if anyone has the circuit diagrams for a Q-2 module - we'd likely only be converting 1 of the 4 channels in the module as we want to distribute the...

One common use for this would be using LED fixtures on dimmers not designed for low wattage loads - by placing a synthetic load in parallel withe the low wattage, you create a load consistent with what the dimmer was designed to accommodate.Also works good for keeping you warm on cold show...