Recent content by MilesDenison

I may have stumbled across it. Strand Premiere? This appears to be the processor unit.

It does say "SDMX/DMX IN" on one of the indicator lights, and goes with the rest of the Strand system there - the connector that's dangling there is attached to several HHR (handheld remote?) terminals on the terminal block strip.I believe it's a piece of strand hardware, merely by the...

All -I just started working in a new space, where there are all sorts of what I believe to be Strand Outlook control panels, none of which have power to them.I believe the attached unit is the culprit... However, I'm entirely unsure what this unity actually is. Can anyone tell me? I believe...

That gear must be extremely well shielded. And well funded.Sent from my SGH-T999 using Tapatalk 4 Beta

We do. Definitely :-)Sent from my SGH-T999 using Tapatalk 4 Beta

I think in our situation, it's much worse with our video system. We run coax lines with RF modulators for video monitoring up into the booth, backstage, in the green room, etc. That hits one of our bands pretty hard.Where are you using 200+ transmitters?

Is there any way that the head engineer for the summer can have a few hour training session, in which a gig can be dry run to have everyone get a feel for it? For someone who hasn't been exposed to a digital console before, the stuff can be pretty foreign (particularly on the DM series, which is...

Unfortunately, it looks like you'll either have to sacrifice one of your effects (perhaps the LCR delay, since that's a bit worrying in the first place).The stereo lines can be used as nice returns (a fairly typical setup for most things).Or, conversely it could be done in a slightly hook...

Have you got the Tx/Rx antennae flipped?I seem to remember that pressing and holding the select button on the base station will scan for a clear channel, might give that a try.Sent from my SGH-T999 using Tapatalk 4 Beta

When you scanned through each frequency, were all of the other receivers/transmitters on/had a pilot tone active, if applicable? Once you scan through/adjust, take another couple of passes through turning each transmitter off and checking what sort of signal you have on the receiver.Also...

We've got 8 SRM450s that provide some sort of flexibility as monitors and such (not the greatest, but the price was right at the time). As a base target sort of gig, I suppose we could say a 1000 person, family style event (lawn chairs and picnic blankets), with jazz fusion and light rock as...

Because I'm working to almost completely rework what we've got, new subs could be up as an option. But, we normally aux feed (and cover a wide, wide range in genres and types of productions and gigs), subs are something that we can borrow when we need them (a few dual 18s, a few single 18...

I second what AudJ and Simps are saying.I would look at my Outport settings (to be sure one isn't attenuated way down) and Bus settings, though it sounds like it may be something a little simpler (mix master isn't cued on).Also, when you say it isn't showing anything, is that on the meter...

I'm on a somewhat limited budget, looking to purchase a new set of active tops. We handle all sorts of different sized crowds, both indoor and outdoor (though these tops would see the bulk of their mileage outdoors).My thoughts were going in the active direction for ease of use and easy...

As I understand your current situation (I could be entirely off base), you would need an A/D unit for this application (assuming the console doesn't have digital outputs). AES3 (AES/EBU) is a digital signal; you would need to take an analog stereo output from your console, run it through the...