seanandkate's latest activity
-
@Matthew Peters bonus points to you from the CB staff. This is exactly how we like people who represent companies to act on CB. You... -
seanandkate replied to the thread I-Cue, PATCHING PAN AND TILT.LOL. Truth. At risk of lighting up our collective OCD, I give you the UNcropped shot...*** TRIGGER WARNING ***
-
-
My assumption was that one of those XLRs went through the birdsnest of cable and someone had clipped the other end in an attempt to...
-
seanandkate replied to the thread I-Cue, PATCHING PAN AND TILT.Sorry, I thought it was the most obvious one based on what you could see in the picture: nothing plugged into the input port, therefore...
-
seanandkate replied to the thread I-Cue, PATCHING PAN AND TILT.Update: All's well that ends well. Found the issue.Much texting back and forth, but as @cbrandt noted--it's all about the...
-
-
seanandkate replied to the thread I-Cue, PATCHING PAN AND TILT.@TimMc Profile says Orlando. If anybody in Boothland has the time and interest and is closer than me here in Toronto...
-
From my perch on the Roost of Curmudgeonly Observers:I am perplexed as to what failure of instruction and/or education has led to a...
-
The other thing to check on the express(if all 3 I-Cues remain not working after the steps listed above) is that port 2 on the express...
-
seanandkate replied to the thread I-Cue, PATCHING PAN AND TILT.Quick correction to the patch. I didn't see the second picture you posted. It looks like your IQs have been patched to 2/1, 2/3, and...
-
seanandkate replied to the thread I-Cue, PATCHING PAN AND TILT.IQ mirrors come in two styles, depending on the age of the unit. It will either have a digital display on the unit which will allow you...
-
seanandkate replied to the thread I-Cue, PATCHING PAN AND TILT.IQ mirrors, depending on you set them up, can be controlled by 2 or 4 control channels. In simple 8 bit resolution, it takes two...
-
seanandkate replied to the thread I-Cue, PATCHING PAN AND TILT.All good my friend. I'll go out on a limb and say that everybody here on Control Booth has been where you are. OK, so let's go through...
-
seanandkate replied to the thread I-Cue, PATCHING PAN AND TILT.OK so if NONE of them are moving, here's what you check next:First, make sure that the power supply is getting power (that black box...
-
seanandkate replied to the thread I-Cue, PATCHING PAN AND TILT.Your patch is a little messed up. I think your patch should probably look like:Ch 31 @ 4 Ch 32 @ 515 Ch 33 @ 516This one is fine...
-
seanandkate replied to the thread Conventional Fixtures Using a Gobo in a Source 4 70 degree.Two 50deg would cover 50' of wall with 57 fc.Here's an ETC app you might find useful as you are playing with scenarios.
