Recent content by thesigma

Thanks...Wonder why that part of the ultratec sie never came up in any of my dozens of searches over the last 2 years....

No one?Anyone have a picture of the inside of a neutron pro?I could only find one in google image search, and it has the cover on but the heater tube sticking out looks like the XS, and the PRO I have does not. The heater was replaced though, according to the seller. Again it does seem to...

Can't find much on the neutron pro.I own three Neutron XS, 1 not working right. 2 I use at my church and am going to sell to them. I picked up a Neutron Pro on Ebay, not realizing it was not an XS. It arrived yesterday in a beat up box but seems to work, other than the output is "bursty", not...

Thanks, I've emailed Alan.already had the spec sheet.

I have been running Lighfactory on a cheap (300 ish) Intel ATOM netbook, with no major issues. LF is not cheap, I would recomend DMXIS or DPRO fora cheaper solution, though I have not used either in depth.In LF i can use note triggers to trigger any shortcut (and a shorcut can do many things...

Anyone have one.... I picked one up dirt cheap and was hoping to be able to use it at my church so they could put some lights on if I'm not around.... maybe it's simple enough I won't need it. first task of course is to power it up and see if it does anything at all......Thanks

Hah, tilt, knew I was forgetting something, though I doubt it is his problem. Basically, as a signal travels along a length of cable the higher frequencies attenuate faster than the low ones, eventually you get to a point where low frequency channels look good, and higher ones get grainy and...

I like the Rip-Ties, we never had a problem using them outdoors, but then again I tend to walk along the cable when I coil it up (over under style), rather than dragging the cable to me. never had a problem collecting debris in them that way. also you can get them big enough to put around a...

Until last year I worked as an AV tech for the local school board (I am now a radio Engineer). Iwas responsible for the CATV distribution system for over 21 buildings and worked on nearly all of them during my 5 years there. There are dozens of things that can cause a "low Quality Signal". If...

I have this one, bought at the local home improvement store for 5 bucks....don't use it a lot but when I do, it works fine.....

This is true but if you are running a home run back to a power supply/data splitter, it should suffice for such a small light, and again, is dirt cheap. And since this is the "worlds Smallest RGB DMX light" we are talking about, an RJ45 would be much smaller than any 5 position trminal strip I...

Pretty much what I described earlier, except I suggested Cat5 with RJ45's, cheap, readily availible, and quick to swap.

That Idea was considered initially, and may be the way I go, I'm just not to fond of the original connectors (Sure-Seal) in an application where they will be mated and unmated every time I break them out (once a week at minimum). I fear they will fail, plus they are a pain in the rear to get...

That looks good. These must be new, never seen them before, and can't find them on the Neutrik site (which I did check before posting).Thanks,

Don't want to have to use a barrel anyway, for that exact reason, and bulk. adding a barrel gets to about the bulk of two nema 5-15's.