Our Orchestra purchased 80 new music stands a few months ago. I have been struggling with them randomoly "Flickering" or "blinking" off very quickly and randomoly in the orchestra.
They are DMX Controlled, address 1 into an ETC gateway controlled by an Ion with 2.9 Software. I made my own fixture profile, they have an intensity, color temp, and 6 zones of control for the attributes.
I can control them fine, but when i use them at 100% The problem gets worse. When I put the Intensity Main and all zones at 90% it calms down but is still there.
I have tried putting a "Ghost load" 375w lamp on the circuit with the powersupplies. It makes no diffrence.
Anyone have any thoughts, or have worked with this particular fixture?
Attached are the manuals that seem to be the most accurate for these fixtures (There are multiple that overlap/have conflicting information)
The next thing I'm going to try is not using DMX to control them but just have them ON from the PSU.
They are DMX Controlled, address 1 into an ETC gateway controlled by an Ion with 2.9 Software. I made my own fixture profile, they have an intensity, color temp, and 6 zones of control for the attributes.
I can control them fine, but when i use them at 100% The problem gets worse. When I put the Intensity Main and all zones at 90% it calms down but is still there.
I have tried putting a "Ghost load" 375w lamp on the circuit with the powersupplies. It makes no diffrence.
Anyone have any thoughts, or have worked with this particular fixture?
Attached are the manuals that seem to be the most accurate for these fixtures (There are multiple that overlap/have conflicting information)
The next thing I'm going to try is not using DMX to control them but just have them ON from the PSU.