Stagemanager01
Member
Ok- I’m a newbie to adding nodes.
I’m using a Etcnet2 Node to get me universes 3-5. I configured the node in the software for the appropriate port outputs for the universes and it sustains an appropriate IP address. When everything first boots up, it works fine, lights and all, but then after a few minutes, the green lights on the port blink indicating it’s not outputting EDMX (even though it just was). Sigh. What’s going on? Is it on the board side that I’m not setting up? I’m operating a Classic Ion.
I’m using a Etcnet2 Node to get me universes 3-5. I configured the node in the software for the appropriate port outputs for the universes and it sustains an appropriate IP address. When everything first boots up, it works fine, lights and all, but then after a few minutes, the green lights on the port blink indicating it’s not outputting EDMX (even though it just was). Sigh. What’s going on? Is it on the board side that I’m not setting up? I’m operating a Classic Ion.