Recent content by remdim

  1. R

    QSC KLA Road Case w/ Rigging?

    I'm currently using KLA's on Eventer 20' lifts; 3 boxes/lift. Set-up/strike is done easily due to custom road cases that house all 3 assembled boxes with their fork adapters and rigging attached...I essentially just roll up, hook onto the lift, and crank up/out.These rolling cases were custom...
  2. R

    Carpet/Runner/Cover Suggestions for Floor Run Cable Safety

    I've got a total of 6-8 XLR and cat5 cables that are run temporarily on a weekly basis in a school gym. About 20 feet of this is in an area with light foot traffic; enough to need stable safety covering. My guys have been using gaff but to save time I'd love to move to some sort of carpet or...
  3. R

    Reasons not to get cheap moving head lights

    We've used a few of the par fixtures from Blizzard with varying degrees of success. Being that they are in the ADJ/Elation Pro range there are absolutely some compromises. The units between $200 and $500 usd I have are quite bright for the price, but the build quality/menu complexity/dimming...
  4. R

    Small Line Array Rigging - Safe and Simple

    Hi All,I'm in a bit of the same boat; looking at getting a few KLA's up in the air but in a school gym. The hoists would be professionally installed; I would then be able to simply roll in a case with the KLA's inside, attach my mount to the electric hoist, and have them flown for the event...
  5. R

    Control/Dimming Jands Vista v2 Questions

    Thanks for your replies; all very helpful. I updated the software and will keep an eye on connectivity. millamber, I checked out the link you posted and found the idea of treating the fixtures as dimmers further down the page. I thought that was interesting and gave it a try; so far so good...
  6. R

    Control/Dimming Jands Vista v2 Questions

    Hi All, I recently had a small venue room outfitted with (16) Elation Pro Opti Tri Pars and Jands Vista v2 running on a Mac Mini w/ a M1 wing. (2) quick questions: 1) I'm looking for fool-proof color mixing based off the faders. The people that will be using this board are accustomed to...
  7. R

    Reflector Removal!!!

    Where did you buy replacement reflectors from?
  8. R

    new member question

    Hello- I'm looking for some lighting simulation software...nothing too fancy but a decent picture of what different set-ups could look like. I tried LightConverse but it's blocked on my network at work. Any suggestions! THANKS!
Back