Here's one that has me totally stumped. I've been using QLC+ on a notebook and on my office PC. It runs into an Enttec DMX Pro box. Everything was working fine. But then, I decided to put QLC+ on one of the PCs up in the booth to avoid taking the notebook up there all the time. I installed the exact same version of QLC+ and serial drivers as on the notebook. The install went smoothly, QLC+ saw the DMX Pro and seemed to communicate with it (green light started flashing). BUT I got nothing from the lights.
Now here's where it gets strange. Somehow or other, the configuration or drivers or whatever apparently got confused in the DMX Pro because the box will no longer work on either of the two PCs it used to work on!!!???!!!
I tried multiple lights and multiple cables, so I can't imagine that to be the problem. I also tried the Enttec control software directly. It sees the DMX Pro, apparently communicates with it, but nothing gets to the lights. Same with Magic Q - sees it, appears to work, but nothing. I also tried re-flashing the firmware in the DMX Pro with no help.
So at this point, I'm baffled. Any thoughts on what might be going on here???
Now here's where it gets strange. Somehow or other, the configuration or drivers or whatever apparently got confused in the DMX Pro because the box will no longer work on either of the two PCs it used to work on!!!???!!!
I tried multiple lights and multiple cables, so I can't imagine that to be the problem. I also tried the Enttec control software directly. It sees the DMX Pro, apparently communicates with it, but nothing gets to the lights. Same with Magic Q - sees it, appears to work, but nothing. I also tried re-flashing the firmware in the DMX Pro with no help.
So at this point, I'm baffled. Any thoughts on what might be going on here???