Recent content by PositiveCharge

Hi All,I work at a venue in NYC and due to some personnel changes, we no longer have anyone on staff who has an E27 cert in order for us to use haze in the theater. Pretty much every designer wants to use haze at this point so it's a major stopping block at the moment. I've been told by the...

Hi All,Wondering if anyone else running ETC Net3 has any tips and tricks for general maintenance of the system. I'm going to replace the battery backup and decided it would be good to service any other parts of the system that are serviceable. I've noticed that the fans seems to always be on...

That’s a great idea. The only thing to consider is if the snow cradle will affect the trajectory of the balls dropping straight down. They need to land on a specific spot. I’m wondering if the snow cradle will give them a slight push upstage or downstage. Going to give it a shot though! Thanks...

Hi All,I need some suggestions for how to construct a container to hold about 15 tennis balls that can be rigged to drop on a cue. A kabuki drop for the bottom of the container would make the most sense, does anyone have any hardware recommendations?The operator would be on the fly rail at...

yes it is, good question

Hi Everyone,I have a renter that is utilizing one of our flex spaces as a large dressing room. They need a lot of power for hair dryers, steamers, clothes irons for wardrobe, etc. I have a 200A disconnect with cam-lock connection in the room. They want to bring in a 400A Lex distro and only...

Great! Thanks for the lead and the part number!

Hi All,I have a large number of Selecon Acclaim fresnels that are missing the gel frame clip. We often use barn doors with them and while the barn doors are always safetied, it's frustrating that they can fall out unexpectedly during focus, etc. Does anyone have any suggestions on how to get...

Hi All, I'm troubleshooting a Colorkinetics Colorblast 12 RGB unit (discontinued) and I'm having trouble with half of the red emitters. They are constantly at a low glow (maybe 0.5%), and these emitters do not respond to data. The other colors and half of the red emitters respond as expected...

Thanks Todd, that's a great idea to check with tape before glueing. How did you find replacement magnets? I can't find the one that is missing on the Seachanger, unfortunately, and haven't found any luck elsewhere online for this specific magnet size and strength. Thanks in advance.

Thanks for the response. I've checked out Pixelteq and emailed Tom, but the email bounced back, and of course, so did an email to Ocean Optics. It seems like Ocean Optics vanished without a trace along with Pixelteq, or Pixelteq is in a different market now. Will give the other ideas a shot...

Hi All,I have two Ocean Optics Seachangers where the green color wheel can't calibrate because of a missing magnet. I have some replacement magnets and glue that will likely be only a quick fix and not last. Has anyone had success with tracking down replacement parts for Seachangers? Thanks...

Hi All, following up. The issue appears to be resolved by changing the settings in the CEM on the dimmer rack. Since I have started working in this space, I didn't check that the configuration was correct since everything was working properly. The CXIs were using a circuit with a relay card, but...

Great idea, thanks

The power supply may very well be the culprit since it is old as you have mentioned. Thanks for the suggestions.