GoboMan
Active Member
I'm currently working on a show in which the client has rented an Ultratec Radiance Hazer to be used throughout the show. We would like to be able to adjust the output levels via the lighting console during the show.
The problem I am having is that the hazer is not responding to any DMX input whatsoever. I double checked the address setting on the hazer, the patch on the board, all DMX cables, and made sure my DMX chain was terminated. No matter what, whenever we turn on the hazer and it completes the warm-up cycle, it will begin pumping out haze continuously, even when the console channel is set to zero. We are using address 200 for the hazer, so I know it is not in "stand alone" mode. Also, the red LED indicating "Valid DMX Input" is lit up and steady.
I'm out of ideas for troubleshooting. If anyone else has had this problem and/or knows of any solutions, I would love to hear them. Thank you!
The problem I am having is that the hazer is not responding to any DMX input whatsoever. I double checked the address setting on the hazer, the patch on the board, all DMX cables, and made sure my DMX chain was terminated. No matter what, whenever we turn on the hazer and it completes the warm-up cycle, it will begin pumping out haze continuously, even when the console channel is set to zero. We are using address 200 for the hazer, so I know it is not in "stand alone" mode. Also, the red LED indicating "Valid DMX Input" is lit up and steady.
I'm out of ideas for troubleshooting. If anyone else has had this problem and/or knows of any solutions, I would love to hear them. Thank you!