But you will not get full brightness from them as two fers; half of the sine wave goes to one leg and the other of the sine wave goes to the other.
Filament latency will cover the 30 Hz waveform, but not completely.Best use a real two fer unless doubling is really needed; then back to the 77v...
Although you already have a D/A converter, I have been very happy with the ones from NorthlightDMX and they are small enough to install inside most equipment.
I've been told by others to look up a local company that makes trophies and awards because some of them have metal etching lasers that might take graphics input for their machines.
I haven't completed the research, but was gonna try to have them cut Rosco Matte Black Cinefoil.Might be worth...
Look on the back or pop the top and look inside; sometimes the wiring diagram is there.
Failing that, it's usually a connector on back that takes 0-10 volts DC to operate each channel.
If you're not very good with a soldering iron or figuring out circuits, you might want to take it to an...
In the US, a common circuit would be a 30 amp, three phase circuit, usually with a 5 pin plug (L21-30).
After wiring one dimmer into each leg of 120v, I could put three PAR64s on each leg but it would be 85 percent of breaker capacity.
I would then change the dimmer curve for those dimmers to...
Some dimmers and dimmer racks can be split among the three phase legs, making maximum use of the power available.I have dimmers that I put on two legs of a three phase circuit and it works just fine.
Generally keep the max load to 80 percent of the capacity of the breaker.