-
-
The big issues you will run into with an old ENR rack are bad AirFlow sensors on the processor (not a cheap component to replace) and... -
One important note: The hole in an ETC c-clamp is slightly smaller in diameter, thus will not take an Altman stud or 1/2" ID pipe...
-
@Matthew Peters bonus points to you from the CB staff. This is exactly how we like people who represent companies to act on CB. You...
-
Just the wording in the lawsuit that presumes Martin lost sales to ETC because of similar handles on the yoke and not because of a...
-
If you are looking for the 510 C-Clamp Center Stud piece the part number is 23-0001 and we have some in stock. If you have any other...
-
Les replied to the thread C-clamp part needed.Spigot, possibly? You could try calling Altman, assuming I have the type correct. As far as I know, the spigots are pretty much...
-
-
Les reacted to egilson1's post in the thread Another attack in a theatre - Keeps happening again. Can we do anything? with
Like.
FYI there is an automated filter for foul language. So it’s not necessarily that a moderator censored a post specifically but rather the... -
Les replied to the thread LYCIAN 927 Ballast Wiring.Also voicing my support in calling Lycian. I needed a minor part for a probably long-discontinued spot and I found them to be...
-
Les replied to the thread Flaking paint on S4 reflector housing.I have seen this happen but it has never posed an issue for me. The fixtures are cast aluminum so while they can theoretically corrode...
-
Les replied to the thread "Other duties as assigned".I understand the desire for auto- toilets and sinks in K-12 educational facilities. With some kids, anything that can be left on, open...
-
It seems that a lot of facilities move towards these for cleanliness. Not because people are getting sick from touching surfaces, but...
-
Les replied to the thread Is buying used moving light fixtures worth it?.FBET ERR I believe is an issue with the motor driver chip(s), but could also possibly be an obstruction or problem with the optical...
-
Les reacted to jon.hole's post in the thread FLX S48 vs. FLX vs. Colorsource AV40 control console with Like.
Hi @Gpquinn , I'm from Vari-Lite, who manufacture the FLX range.Of the three consoles you mentioned, FLX S48 is most closely...
-
Les replied to the thread Painting FOH Bulbs.Years ago I visited a convention center with what appeared to be a 50/50 mixture of Metal Halide and HPS fixtures, laid out in a grid...
-
Context is all. I'd interpret strike the lamp as make it light - lamp on.I'd interpret strike the revolver as remove the revolver from...
-
-
Loading…
-
Loading…
