Recent content by WLProductions

When I try to load the software of the Jands site it will not load into the desk . It keeps giving me a "Program not Found " notification . Does anyone have the software for a Jands Hog 250 ? Or know a site I can get a good version of it ? Also is the jands 250 software the same as the Whole Hog...

Hey guys I have a old Jands Hog 250 that I dug out of storage and I was looking to put it back into service . I am experiencing a couple of issues listed below and I am very curious to see what you guys think the problem may be . I have not used this desk in years and it worked fine when I put...

Thank you so much cbrandt you nailed it that's what I'm after faders and bumps at my finger tips . I will definitely go try a few thank you !!

That's kinda what I was leaning too as well , I'm gonna do some serious research on the pearl line . I want to thank you guys for taking the time out of your busy days to answer these questions ! I got to get rid of these multiple leprecons (what we have named Frakenconsole LMAO ) its always...

Hilariously I have ran all this by multiple leprecon lps LMAO dodgy I know but hey it works ! That's why I'm here

Here is what we run normally but as all of you know that can very , but our standard rig we use weekly consists of this .40k pars some rays 6mac 250s 4 atomics 6 led Colorado's 4 intellabeams 4 cycs 4 legend 250rxs

I really would like too stay away from PC wings , I personally love my old Leprecon Lp,s have used one for 10 years now . So I was thinking on trying to stick with them . Any thoughts on the Leprecon LP x48 ? So far on the desks mentioned here I am liking the avo pearl . I found a avo pearl 2000...

I don't mind buying used to fit our budget .

Thank you ! I will start researching today on that line I also probably add our budget is in the $5000 dollar range . How about a zero88 frog ? Any one had any luck with them ?

I have been running 2 leprecon LP1536s for quite sometime to run our rigs that incude conventionals and moving lights . Needless to say our desk is much older then our rig and it has taken some engineering to get it all going lol . But its time we make the big move to purchase a new desk for...

We had to dig out one of our old consoles last night and seem to be having a issue that is really pissing me off . It is a Leprecon LP1536 , when the console is powered down it looses all its settings and has to be erased before it will start behaving properly . Its really strange as when you...

We just picked up a great deal on 10 chauvet legend 250rx with only 5 to 10 hours on each fixture . They are really nice for a chauvet product ! But as I know they are older and chauvet is horrid about discontinuing things I want to keep them at peak performance for as long as I can .

We have had a few sets of those for some of our bar/club rigs . Is it the same green row of lights on both ?

So we just got some new movers we got in and I wanted to see what you guys had to say about proper maintenance to keep them in perfect condition and extend there life to the max . Also what is considered "HIGH" fixture hours on a mover . Thanks fellas !

That's it ! That's what I'm looking for ! Like I said the only reason I'm asking such a question is because I remember my old manual I had for my dreaded celco Ventura had these illustrations in the back of the book . I thought that was pretty helpful and iv never seen anything like it ever...