Greetings to everyone involved with and members of Control Booth. I have come into ownership of 8 Colorblast 12s and the PDS-150e power supplies for the same. I would like to integrate these into my lighting inventory for shows knowing they are best for washes and the likes. The PDS-150e's have Cat 5(6?) sockets labeled for DMX in/out/loop-through. I would have imagined that I could use a 3-pin to Cat 5 adaptor and connect my 3-pin system to the Cat5 inputs for control. So far no luck getting the instruments to show life except for a low glow that simply plugging them into the power supply creates. No response to a manual control board I am using for testing before connecting to anything else. I have to believe there is a place to use dipswitches to modify the addresses but now sure where to find that. Open to advice suggestions or whatever that will achieve control of these instruments. Thanks -- RobinWD