Connecting an I-Cue to an ION board

[Jerry Jonas]

Hi everyone,

I have an I-Cue I'd like to patch into my ION board. I patched it into the board, told it was an I-CUE, it saw it. I can program a ballyhoo effect on it, but I'd like to use the wheels on the ION to control the pan and tilt. How would one do that >

Thanks in advance,

Jerry

 

[Thetechmanmac]

Been a while since I have been on an ion, but heres what I gathered from the manual: (page 45 and 116)
Once you have a fixture patched, you should be able to select it in ML virtual controls, and on the LCD the parameters SHOULD show up for control. By switching between the encoder page buttons to the right, you can adjust all the parameters of a fixture. Pan/tilt will be in the focus page.

Hope this helps...