PrettyFlyForALightGuy
Member
Good afternoon(or whatever the time is where you are) everyone!
I'm currently working with an ETC Ion(old faithful lol) and I've tried making some programming Buttons on a Magic Sheet to speed up the keystroke process. Essentially I'll use a example. There's a macro button in the magic sheet labeled 'Record Group' there's identical buttons for subs, CPs, IPs FPs and BPs. The macro was done from blind mode and is as such:
[Record] [Group] [Wait_For_Enter] [Label] [Wait_For_Enter] [Clear_Cmd]
The objective is to have the command line cleared after I finish labeling the Target(s). I've tried changing the [Wait_For_Enter] to [Wait]. I tried assigning a second delay afterwards to clear the command line but still no luck.
Another issue I'm repeatedly running into is I've created Absolute Color Effects and in the Action sections(1&2) I've selected the Primary Red(1) and Primary Green(2) for the levels. I'm using ETC Series 2 Lustrs in HSIC Str +7(15 but address). I would only like for it to go between the Reds and Greens but I'm always getting the mixing colors. Is there a way to make that possible?
The Color Effect example looks like this:
Action: Parameters: Step Time: Time: Dwell: Level:
1. (2) (1) (1) Primary Red
2. (2) (1) (1) Primary Green
The levels are set from Color Palettes I recorded by-type for the Lustrs. However I get color mixing between.
I'm currently working with an ETC Ion(old faithful lol) and I've tried making some programming Buttons on a Magic Sheet to speed up the keystroke process. Essentially I'll use a example. There's a macro button in the magic sheet labeled 'Record Group' there's identical buttons for subs, CPs, IPs FPs and BPs. The macro was done from blind mode and is as such:
[Record] [Group] [Wait_For_Enter] [Label] [Wait_For_Enter] [Clear_Cmd]
The objective is to have the command line cleared after I finish labeling the Target(s). I've tried changing the [Wait_For_Enter] to [Wait]. I tried assigning a second delay afterwards to clear the command line but still no luck.
Another issue I'm repeatedly running into is I've created Absolute Color Effects and in the Action sections(1&2) I've selected the Primary Red(1) and Primary Green(2) for the levels. I'm using ETC Series 2 Lustrs in HSIC Str +7(15 but address). I would only like for it to go between the Reds and Greens but I'm always getting the mixing colors. Is there a way to make that possible?
The Color Effect example looks like this:
Action: Parameters: Step Time: Time: Dwell: Level:
1. (2) (1) (1) Primary Red
2. (2) (1) (1) Primary Green
The levels are set from Color Palettes I recorded by-type for the Lustrs. However I get color mixing between.