NeroCaesar
Member
In a similar line of Questions:
I have a Doug Fleenor Pre10-A Wall plate
I also have a 5p DMX wall plate in for a board
There is no way around using terminal blocks to connect the two AND then go out to the dimmers.
Is there a better way?
I was thinking hard wire the 5pin input and the DF wall plate and run that to an iso which runs to the dimmers
Any thoughts?
I have a Doug Fleenor Pre10-A Wall plate
I also have a 5p DMX wall plate in for a board
There is no way around using terminal blocks to connect the two AND then go out to the dimmers.
Is there a better way?
I was thinking hard wire the 5pin input and the DF wall plate and run that to an iso which runs to the dimmers
Any thoughts?