Massey28694
Active Member
Hey guys, I'm back! Just purchased our new Element 2-6000 and we are doing a self-install (dealer is 3 hours away!). So far, so good, but we cannot get the iRFR to work.
We have downloaded the RFR Classic on iPads. Pretty simple setup there, put in the IP and password as shown on the console, but cannot connect. Our setup is internet service going to a TP-Link mesh network, ethernet from the TPLink to a Linksys E4200 router (we plan to make this router private for lighting only). From the router, we are hardwired from a lan port to lan port 1 on the console.
Console shows "connected". I have gone over the instructions a dozen times and believe I have everything on the board set correctly. When we try to connect the iRFR, no connection is found. I have a laptop hardwired to the Linksys router and have done a hard reset on the router, so it's at defaults.
IF I move the network cable from console port 1 to port 2 (the internal ip side), I CAN ping that IP address! But when I put it back on port 1, the console shows "online", but I cannot connect or ping.
Likely doing something very simply wrong, but cannot figure this one out! Any help you can give is appreciated!!
We have downloaded the RFR Classic on iPads. Pretty simple setup there, put in the IP and password as shown on the console, but cannot connect. Our setup is internet service going to a TP-Link mesh network, ethernet from the TPLink to a Linksys E4200 router (we plan to make this router private for lighting only). From the router, we are hardwired from a lan port to lan port 1 on the console.
Console shows "connected". I have gone over the instructions a dozen times and believe I have everything on the board set correctly. When we try to connect the iRFR, no connection is found. I have a laptop hardwired to the Linksys router and have done a hard reset on the router, so it's at defaults.
IF I move the network cable from console port 1 to port 2 (the internal ip side), I CAN ping that IP address! But when I put it back on port 1, the console shows "online", but I cannot connect or ping.
Likely doing something very simply wrong, but cannot figure this one out! Any help you can give is appreciated!!