Was wondering if anyone has had this issue while using Jands Vista Byron: After patching all my fixtures, all of them decide not to accept any commands. All during patching I would have the highlight mode turned on to make sure that the light responds to the correct patching. Everything checked out, but now that I am ready to start going further with clips, cues and such, none of them want to work. Any suggestions? Did I miss a step?
Im on Byron version 2.2.10545 and am using an S1 board. Computer is an iMac i3 processor. We just got a new dongle for 1024, but dont see why that would be hindering things, but there's that info.
Also does anyone know where I can get a fixture profile for a Wybron CXI 3ch scroller? They have some built into Byron, but none of them seem to be the right ones.
Thanks,
Adam
Im on Byron version 2.2.10545 and am using an S1 board. Computer is an iMac i3 processor. We just got a new dongle for 1024, but dont see why that would be hindering things, but there's that info.
Also does anyone know where I can get a fixture profile for a Wybron CXI 3ch scroller? They have some built into Byron, but none of them seem to be the right ones.
Thanks,
Adam