russix
New Member
I am doing some volunteer work at my church and we are trying to move the architectural lighting control to a new room that was added. Ultimately it would be DMX and could tie into our other DMX lighting control software/hardware. I'm not sure if that is possible with this older system.
Here is what we have:
I looked a the wiring and there were 14 wires going into the 6-button panels. The master control had even more wires. The main enclosure / panel (LM-1616) wiring was even crazier.
What is the easiest way to move the master control to a different wall?
Here is what we have:
- Lightolier LM-1616 enclosure.
- Various LM-xxxx dimmer and non-dimmers
- Two LM-8080 modules
- One master wall control panel. 6-button (on/off/A-D) plus four faders. (back says Lytemode II 16 output power BD.)
- Two other panels in different locations that have only the 6-buttons. (P/N: 82-0245 Rev B)
I looked a the wiring and there were 14 wires going into the 6-button panels. The master control had even more wires. The main enclosure / panel (LM-1616) wiring was even crazier.
What is the easiest way to move the master control to a different wall?