Okay, so I got my lights from China (US seller), first time going that route. they are led pars. I also have microphone cable, not DMX. 6 ft long pieces. I have a DMX terminator/signal tester on the end of the chain, and if I attach more than 1 light in the chain, after 30 seconds of dmx'ing the led on the tester goes red, which indicates pin 2 could be stuck low or pin 3 is stuck high. Then, my DMXking ultraDMX micro flashes slow, indicating either "Receive mode, no DMX512 stream detected. Power ON indication." or "Receive mode, DMX512 stream detected. Flash rate = DMX update rate." I have to restart freestyler and re-plug in the dongle and it resets, and then does the same thing again. It is fine when only one light is plugged in, but after I attach 2 or more it does this.
Last edited by a moderator: