Patching Elation Design Spot 250 Pros on Palette OS

[Jinkley]

Ok. Our auditorium recently installed 6 movers (two Elation 575Es, and four Elation Design Spot 250 Pros). I patched in the 575Es no problem, and in the patch section it reads at 'Attr:' in the Pallete Software as 2.199. Second universe, address at 199 right? The other reads 2.229. Both of these lights are patched and working. The four 250s are a different story. The lights are addressed addresses are 280, 300, 330, and (I was experimenting with this one) 460. I patch them all into the second universe, just as I did with the 575s. The lights move, and strobe different colors. I can tilt, but I can't pan, everything is just bleh. I have 'half' control. Do any of you wonderfully smart veterans have any advice?

Here are some screenshots of the patch section:

 

[Jinkley]

Admins, I got it. You can close and lock it. You have truly been gentlemen and scholars. I think it just took me to type it out to understand what I was doing wrong.