bobcatarts
Member
It's early, and I haven't had enough coffee. What I have had enough of, however, is this Proxima 9290 projector I found, covered in cobwebs and dust in the back of my copy room.
When I plug it in, the Lamp Indicator light is red, and the Ready light goes green. When I hit power, the fan spins up to full, then down, and then after a minute or two it just shuts off.
The only manuals I can find for it - our analog copy is long, long gone - say DRAFT across the top and the picture of the machine is close but not quite right. The position of the indicator LEDs on the image is wrong - across the front, whereas my machine's are down the side, on the top cover.
That manual says that the LED patterns I'm seeing indicate everything is OK, and if it were a blown lamp the Lamp Indicator would be lit. Fascinating.
Any suggestions before I start unscrewing things? This projector isn't in our inventory, so it's not like I've missed its absence.
Thanks everyone!
-Robert
When I plug it in, the Lamp Indicator light is red, and the Ready light goes green. When I hit power, the fan spins up to full, then down, and then after a minute or two it just shuts off.
The only manuals I can find for it - our analog copy is long, long gone - say DRAFT across the top and the picture of the machine is close but not quite right. The position of the indicator LEDs on the image is wrong - across the front, whereas my machine's are down the side, on the top cover.
That manual says that the LED patterns I'm seeing indicate everything is OK, and if it were a blown lamp the Lamp Indicator would be lit. Fascinating.
Any suggestions before I start unscrewing things? This projector isn't in our inventory, so it's not like I've missed its absence.
Thanks everyone!
-Robert