BlackoutGo
Member
Hi, I just replaced my middle plate, gasket, copper inlet and outlet pipe, and the silicone tube from the t connection to the inlet. I had pulled off the airline check valve during disassembly.
I am controlling the device via dmx and it was operating fine (until the large carbon deposit occurred). However, now that I have replaced all the parts, there seems to be a constant stream of haze being outputted even though there is no dmx value being sent to it. I have flipped the airline check valve to see if I had re-installed it in reverse and it still outputs haze out.(one direction causes it to output even more). If someone would be able to send me a picture of the correct direction of the airline check valve (there's a plastic arrow on it), that would be appreciated.
I will be calling Ultratec in the morning if I can't solve the problem tonight.
Happy Thanksgiving.
I am controlling the device via dmx and it was operating fine (until the large carbon deposit occurred). However, now that I have replaced all the parts, there seems to be a constant stream of haze being outputted even though there is no dmx value being sent to it. I have flipped the airline check valve to see if I had re-installed it in reverse and it still outputs haze out.(one direction causes it to output even more). If someone would be able to send me a picture of the correct direction of the airline check valve (there's a plastic arrow on it), that would be appreciated.
I will be calling Ultratec in the morning if I can't solve the problem tonight.
Happy Thanksgiving.
