Hey All,
I have a few Q-spot 575's in my inventory, and I am having an issue with one of them. Now I know that these fixtures are quite old, and I don't have much hope of getting them working again but I thought I would try anyways.
One of my fixtures fails to go through the boot cycle. I have it and a second one pulled apart and have been trying to figure out which component is bad. Once plugged in and turned on, the fixture will strike the lamp as it should. About 10-15 seconds after the bulb strikes, the bulb will then shut down and it will not continue on the the boot cycle. My first thought was to change the bulb igniter. I switched the igniter from a working fixture with no change. The bulb igniter from the broken light works just fine in the second one. I have also tried switching the memory chips from the good light to the bad one with no change as well.
Before I go trying to switch every component in this light, I was hoping someone might have some insight for me. Thanks much!
Jon
I have a few Q-spot 575's in my inventory, and I am having an issue with one of them. Now I know that these fixtures are quite old, and I don't have much hope of getting them working again but I thought I would try anyways.
One of my fixtures fails to go through the boot cycle. I have it and a second one pulled apart and have been trying to figure out which component is bad. Once plugged in and turned on, the fixture will strike the lamp as it should. About 10-15 seconds after the bulb strikes, the bulb will then shut down and it will not continue on the the boot cycle. My first thought was to change the bulb igniter. I switched the igniter from a working fixture with no change. The bulb igniter from the broken light works just fine in the second one. I have also tried switching the memory chips from the good light to the bad one with no change as well.
Before I go trying to switch every component in this light, I was hoping someone might have some insight for me. Thanks much!
Jon