ADJ LED Mover not responding

[carsonld]

I have 18 Blizzard Puck Q6 leds, one American dj inno pocket Z4, and two dimmer packs on one DMX line with a terminator. It goes to a ETC Congo kid. Last night when they powered everything on, the inno pocket would not reapond to the board. It acknowledged that it was not in party mode, but isn’t responding to any of the cues. I also had one blizzard par randomly flashing. I took the flashing par out of the line thinking that would fix it. I got nothing. So I ran a single line from the board to the mover and it works perfectly fine. So I’m assuming it’s something in the dmx line. Thoughts?

Hopefully this is enough info. Show is at 8 and I’m trying to troubleshoot now.

 

[Amiers]

Run a new line. If you have all of that talking on one feed it might be getting pissy.

Could try to throw an optosplitter from the end of the homerun and branch each thing individually but I don’t see that happening if you don’t have the gear on hand.

 

[Mac Hosehead]

Can you run two lines? I thought the Congo had two outputs. I am always suspicious of dimmers on the same line as fixtures.