Hey all, I've got an Apollo EZ Iris that's been in service for about ten years. I believe we purchased it new, but at this point... who knows. It was in service this spring, before the apocalypse. We went back into the space to set up a rep plot; when I put it in our i-Cue fixture, it wouldn't take any signal from DMX. It goes through it's startup test (fully iris out, fully iris in) immediately after it's plugged into the power supply, but after that nothing.
Does anybody know about any of the failure modes for this peice of equipment? I appear to be getting voltage from the scroller cable, into the control board, but beyond that I don't even know where to start diagnosing.
Does anybody know about any of the failure modes for this peice of equipment? I appear to be getting voltage from the scroller cable, into the control board, but beyond that I don't even know where to start diagnosing.