Continuous rotate and shake on WholeHog II

[vincecr]

I was wondering if anyone knew how to enable continuous gobo rotation or shake on a Mac 2000 using a wholehog 2. I managed to suffice at my event by setting gobo rotation position to the sine of x and that kept it rotating back and forth roughly but is there a built in way to do this.

 

[icewolf08]

I don't know the "combination" off the top of my head, but I believe that you need to set a couple of the control channels at specific values. Usually you need to put the gobo wheel in the right position and then the index channel will become rotation speed. It has been a while since I had a MAC 2K in house, but if you pull up the manual I would imagine that it will tell you on the DMX chart for the fixture.

 

[TimMiller]

Set gobo index at Rotate or >> depending on how they labeled the fixture attribute. Then the gobo rotate controls your rotation speed. Same with gobo shake, set index to shake then adjust gobo rotate to desired speed.