TupeloTechie
Active Member
I'm trying to figure out a way to hang a curved cyc that will be used for rear projection. The trick is, it has to be supported from the ground, and I must also be able to hang a black bobinette no less than 6" from the cyc. My first instinct would be to rent 3 truss curves, link them together and stick an L-16 on each side. The screen is only 15' high, so that solves the height issue, and I could hang the cyc on the rear of the truss and the bobinette on the front. However, I'm a little afraid of stability issues. Even though the cyc and bobinette don't really weigh much at all, it seams like I should be using a third stand in the middle. Problem is, I can't because of RP. I've attached a quick drawing of what I'm trying to do. Can anyone give me some pointers or better ideas. I'm open to anything.
Thanks!
Thanks!