grandMA onPC and 3d aren't talking

[DuckJordan]

Well I can get it connected now its showing its the master of a session its joining, so not sure what the deal is with that. One thing to note however is that the onPC is wireless while the 3d visualizer is physically attached to the network

Edit: so for *Explitive* and giggles i tried to connect it locally, (on the same computer) and it connects... Now to get it to work on different computers.

 

[Focus]

Try using wired connections for both PCs. I have had no luck with wifi, but cat5 to the router works fine.

 

[dibbs]

If you have a router involved make sure that the console doesn't have the same IP as the router.

 

[DuckJordan]

Router is set to 192.168.0.1, and the console is 206. Zzz.x.x

 

[Focus]

Connect both computers to a router, unless you have set the PCs to static ip adresses, the Router will give each one a IP using DHCP. It will start with 192.168. In each program under network settings you should be able to set the program to the same IP as the PC. This should tale care of it.

 

[DuckJordan]

So there's no way to leave the laptop(onPC) on wireless?

 

[Focus]

It might work fine, but I have not tryed it recently. I only suggest getting it working over a wired connection first, to eliminate other posible problems that may exist. You may also want to check out MA-share.net

 

[dibbs]

Set your console to 192.168.0.11. Set your computers IP to 192.1688.0.12. Make sure to select this IP in maid as weel