Curious if anyone has experience using a heat gun/Marley Weld for regular Marley maintenance. We are a full-time dance company in Denver, Colorado. We have a massive studio with permanently installed, Welded, wall-to-wall Harlequin Marley. We have a few slices and general use damage on the floor from normal wear and tear. Not enough damage to warrant replacing a panel. Directors would like to avoid using tape on the floor if possible. They hate vinyl tape, and we typically are a gaff company. Does anyone have experience with using Welds to repair small punctures? There doesn't seem to be a lot of information on the web about this. Hoping someone might have thoughts or equipment recommendations. Thanks!